Since the production process of the transformer horn ty […]
Since the production process of the transformer horn type winding machine determines the frequent start-up and constant torque requirements of the equipment, the general parameters that need to be set for the transformer winding machine are.The slow function setting is also a commonly used parameter. It is mainly used to control the equipment to start and stop at a slow speed, play a soft start and stop buffer function, the correct setting can allow the operator to adapt when starting the winding machine In the process of pulling force, when the equipment is parked with a buffer, it can stop more accurately.
The lap setting is the number of laps that the equipment needs to run according to the production process. It is divided into the total laps and the laps corresponding to each step sequence. The setting should pay attention to the total laps equal to the sum of the laps of each step sequence.The running speed is used to control the speed of the equipment during operation. The setting of the speed needs to be determined in conjunction with the production process and the actual working conditions of the winding. Too fast or too slow is not conducive to the formation of the coil, and fast running will not be conducive to the control of the operator.
Increasing the vibration and noise of the equipment, and running at too low speed will greatly affect the production capacity and efficiency of the equipment, and also affect the torque output of the equipment spindle.With the advancement of science and technology, generally speaking, the use environment of automatic winding machines does not have any harsh requirements. Although that is said, because automatic winding machines contain a large number of electronic components, they are most afraid of direct sunlight, moisture, dust, and vibration. All of these can cause the electronic components to be corroded and deteriorate, or cause the short circuit between the components to cause the winding machine to operate abnormally.
These should generally be noted when installing the machine.For users, the main thing is to pay attention to the protection of the surrounding environment. For example, it is necessary to be careful not to bring umbrellas to the production site on rainy days, and to keep the production site tidy. The step-by-step sequence function is used to control the sequence of equipment operation. It is generally determined according to the production process. The forming and winding of a coil is not only the winding of enameled wire, but also many other steps such as paper wrapping, insulating cloth, etc. , So the correct setting of the step-by-step sequence function will effectively exert the efficiency of the equipment.